Last Modified: 11-29-2007 1.6 A
Service Category: Vehicle Interior Section: Seat
Model Year: 2008 Model: Sequoia Doc ID: RM000002XDN002X
Title: SEAT: FRONT SEAT ASSEMBLY (for Manual Seat): INSTALLATION (2008 Sequoia)

INSTALLATION

HINT:

  • Use the same procedure for the LH side and RH side.
  • The procedure listed below is for the LH side.

1. INSTALL FRONT SEAT ASSEMBLY LH

(a) Install the front seat.

NOTICE:

Be careful not to damage the vehicle body.

(b) Connect the seat wire connectors under the seat.

(c) Operate the seat track adjusting handle to move the seat to the rearmost position.

(d) Install the 2 bolts.

Torque: 37 N·m (374 kgf·cm, 27 ft·lbf)

(e) Operate the seat track adjusting handle to move the seat to the foremost position.

(f) Install the 2 bolts.

Torque: 37 N·m (374 kgf·cm, 27 ft·lbf)

2. INSTALL SEAT TRACK COVER LH

(a) Engage the 2 claws to install the seat track cover.

3. INSTALL SEAT TRACK COVER INNER LH



Engage the 2 claws to install the seat track cover.

4. INSTALL FRONT SEAT HEADREST ASSEMBLY

5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable some systems need to be initialized after the cable is reconnected INTRODUCTION: REPAIR INSTRUCTION: INITIALIZATION (2008 Sequoia) .

Torque: 5.4 N·m (55 kgf·cm, 48 in·lbf)

6. INSPECT SRS WARNING LIGHT

(a) Inspect the SRS warning light SUPPLEMENTAL RESTRAINT SYSTEMS: AIRBAG SYSTEM: DIAGNOSIS SYSTEM (2008 Sequoia) .